“SITITEK GROM-125” is a new generation device among dog repelling and training devices. Its operating principle is based on generating pulses at changing frequencies. The repeller generates 125 dB ultrasonic signals and series of 2800 Cd bright flashes that effectively influence dogs, cats and other animals at the distance up to 10 meters. Ultrasound is weak in the training mode,
Ultrasonic dog repeller “SITITEK GROM-125” is a compact device enclosed into the 130x40x22 mm housing. At the front end surface there are two high-brightness LEDs and the port of ultrasound generator. At the back end surface there is a mounting for a strap. According to the selected mode the LEDs glow constantly as a torch or pulse as stroboscopes.
At the top of the housing there is a start button, and there is a three-position mode switch at its bottom: · Torch mode (left position of the switch) – lamp icon. · Training mode (middle position of the switch) – dog on hind legs icon. · Repelling mode (right position of the switch) – running away dog icon.
To power the repeller on you need to open the battery compartment cover and install a 9V 6F22 or “Krona” type battery (included). To inspect the working ability of the device activate the torch mode by moving a mode switch to the relevant position. If LEDs start glowing, the device works properly.
If there is a threat of a dog attack, set the device to the repelling mode (right position of the switch), point the emitting part of the repeller at the dog and push the start button. “SITITEK GROM-125” will start emitting ultrasound signals coupled with bright LED flashes. Slightly change the repeller’s direction to find the most unpleasant direction for the dog, therefore the most effective. Repeat switching the repeller on, if needed, 2-3 times every 2-3 seconds. Common dog’s reaction to the operation of the device is to start moving back and then run away. Ultrasound doesn’t jeopardize dog’s mental state.
Switch the device to the training mode that uses weak and not scary but audible ultrasound and start training a dog, i.e. command as usual (by voice or a gesture) and push the start button simultaneously. After a while the dog will understand what you want and start to execute some instructions supported by the repeller’s signal only.
The repeller can be used as a mini torch. The built-in LED’s operate independently from the ultrasound generator. To switch the torch on, you should set the mode switch to the left position marked with a lamp icon.
WARNING · The repeller is effective against furious and aggressive dogs. The device may be of little effect against sick, deaf or professionally trained dogs. · Do not direct the device at the human’s hearing organs if it is close to them. Ultrasonic repeller influences hearing that may result in buzzing in ears, headache, etc. · Do not use the repeller against dogs who have no interest in you while walking or resting quietly because it may provoke a mixed reaction. · Keep the device away from water.
Technical features: - Repelling is effective at the distance of 10 meters - Power supply: one 9V6F22 or “Krona” type battery - Maximum input: 130 mA - Ultrasound operating frequency: 25 kHz - Sound pressure: 125 dB - Dimensions: 130x40x22mm - Weight: 98 gr. - Housing material: plastic - Color: yellow